11.0 General Node Administration > Managing Node State

Conventions

11.5 Managing Node State

There are multiple models in which Moab can operate allowing it to either honor the node state set by an external service or locally determine and set the node state. This section covers the following:

11.5-A Node State Definitions

State Definition
Down Node is either not reporting status, is reporting status but failures are detected, or is reporting status but has been marked down by an administrator.
Idle Node is reporting status, currently is not executing any workload, and is ready to accept additional workload.
Busy Node is reporting status, currently is executing workload, and cannot accept additional workload due to load.
Running Node is reporting status, currently is executing workload, and can accept additional workload.
Drained Node is reporting status, currently is not executing workload, and cannot accept additional workload due to administrative action.
Draining Node is reporting status, currently is executing workload, and cannot accept additional workload due to administrative action.

11.5-B Specifying Node States within Native Resource Managers

Native resource managers can report node state implicitly and explicitly, using NODESTATE, LOAD, and other attributes. See Managing Resources Directly with the Native Interface for more information.

11.5-C Moab Based Node State Adjustment

Node state can be adjusted based on reported processor, memory, or other load factors. It can also be adjusted based on reports of one or more resource managers in a multi-resource manager configuration. Also, both generic events and generic metrics can be used to adjust node state.

11.5-D Adjusting Scheduling Behavior Based on Reported Node State

Based on reported node state, Moab can support various policies to make better use of available resources.

Down State

Related topics 

© 2014 Adaptive Computing